View Single Post
  #47  
Old 03-19-2014, 02:51 PM
feeble feeble is offline
Junior Member
 
Join Date: Feb 2012
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Default

If I understand the SCCA rules correctly, isn't the diagonal bar supposed to be continuous?

Here is my car:


Several things I'm not real clear about yet are:

1) Height of the harness bar relative to the cutout in the seats (obviously I'll need to figure out what seats I'm going to use.)

2) The harness bar that came with my kit has bends on both ends so that it would not be in the same plane as the hoop when installed. Wouldn't it be better to have it in the same plane?

3) The bars that Ron shows in red were included with my kit but will not work in my car as the subframe connectors connect to the suspension pickup point directly underneath where the main hoop attaches to the floor. Any thoughts for an alternative location?

Thx!
Reply With Quote