View Single Post
  #4  
Old 04-22-2020, 10:26 AM
CarlC CarlC is offline
Senior Member
 
Join Date: Aug 2005
Location: Newbury Park, CA
Posts: 600
Thanks: 12
Thanked 81 Times in 29 Posts
Default

I've tried every method and only one offers a consistent preload setting, the Kore3 solid bearing spacer with shims. When properly set up the 0.0015 end play wheel movement is minimized and and bearing life maximized.

1) Install the hub + bearings on to the spindle without grease or the inner seal.

2) Using the provided shims, adjust until an end play of 0.0015" is met.

3) Disassemble and pack the bearings full, internal housing and cap 1/3 - 1/2 full of grease, install the seals, and reassemble using the same shim and spacer pack.
__________________
http:www.vaporworx.com

Last edited by CarlC; 04-22-2020 at 10:47 AM.
Reply With Quote
The Following 2 Users Say Thank You to CarlC For This Useful Post:
camcojb (04-22-2020), dhutton (04-22-2020)