Thread
:
My 68 Camaro Project
View Single Post
#
4
10-01-2018, 03:24 AM
jasonz28camaro
Member
Join Date: Aug 2017
Posts: 94
Thanks: 2
Thanked 6 Times in 5 Posts
First thing I did was remove the DS package tray reinforcement per DSE instructions. This seemed to not be needed but did make it easier to do. I did not remove it on the PS. Then I went on removing the inner wheel well paint to expose the spot welds. Spot welds suck...
[IMG]
[/IMG]
Next I cut out the inner wheel well and trunk floor/frame per the DSE instruction and use their template so I could mock up the new tubs
jasonz28camaro
View Public Profile
Find all posts by jasonz28camaro