Quote:
Originally Posted by blitzer454
Are other functions of the gauge cluster working like the blinker indicators and other gauges like temp, oil and water? If so then I don't think it's a ground problem. You mentioned that you installed a new speed sender, is the new sender still a SN16 or something else? Did you try going through the calibration steps?
|
Yes all other gauges are are working except the tach and speedometer. The new sender is the SN16.
I am not sure whether the speedo pointer is supposed to move when just putting into first gear for a slow roll only as the car is suspended on 4 jack stands.
The tach, on the other hand, is sort of stuck at 1000 RPM and not functioning at all. I have heard that for LS swap, it requires a pull up resistor like 1K ohms 1/4 Watt.
I honestly have gone through the calibration steps