View Single Post
  #51  
Old 02-03-2015, 12:10 AM
frankv11's Avatar
frankv11 frankv11 is offline
Senior Member
 
Join Date: Dec 2009
Location: socal
Posts: 953
Thanks: 0
Thanked 25 Times in 16 Posts
Default

Quote:
Originally Posted by Revved View Post
Yes, but tight space stuff comes out nicer if you mock it up first... especially when trying to connect two points in space (like an apron to a master cylinder) with multiple lines and make it all look nice.
Agree with both of you. In my case I used mock up because it saves a ton on Ss material and wanted lines to run through very specific points. For example on picture below. That line goes from MC to front passenger wheel , undisturbed ( one piece ) it follows weld line on sub cross member and very tigh on all places. With multiple bends , on multiple planes and odd degree bends ( 13s , 17s etc )
There is no way I could have done it any other way.

The see through protractor was indispensable for me also.

Last edited by frankv11; 02-03-2015 at 12:17 AM.
Reply With Quote