Here’s the front…
10046.6 by
Yelcamino, on Flickr
10046.7 by
Yelcamino, on Flickr
10046.8 by
Yelcamino, on Flickr
10046.9 by
Yelcamino, on Flickr
And then I made a pair of boxing plates and welded them in. (For some reason this is the only picture I took)
10046.91 by
Yelcamino, on Flickr
The next big hurdle was permanently welding the suspension brackets to the rear end housing.
10046 by
Yelcamino, on Flickr
Here you can see how I shortened the back brace to clear the coil overs.
10047 by
Yelcamino, on Flickr
10048 by
Yelcamino, on Flickr
With all the brackets welded on, I made a trip to Moser and had them weld on the Baer floater ends and cut axles for me.
10049 by
Yelcamino, on Flickr
10053 by
Yelcamino, on Flickr
10050 by
Yelcamino, on Flickr
I also picked up some gear oil and axle seals.
10051 by
Yelcamino, on Flickr
And some Redline grease for the axle bearings.
10052 by
Yelcamino, on Flickr
With everything welded, I put the housing back in to see how it all fits.
10055 by
Yelcamino, on Flickr