Ah, I see... I had the guy that finished my last shop floor do that and it was awesome. For a while anyway...until the guy that did my spray in foam insulation got foam all over it. It was smooth enough you could clean it up mostly with a dust mop.
I don't think this floor is smooth enough to do the same. It's not bad but still has a bit of grit to it. Won't be able to tell for sure until all of the construction dust and debris is pressure washed off it.
I'm seriously considering doing Option #2 above though. I bet the finish ends up close to what Charlie has if not a little smoother, I"m just not sure about the sealer put on after. My experience with just concrete sealer has not been good. Once it starts to fail and come up, it can be worse than just plain dirty stained concrete floors.
__________________
Lance
1985 Monte Carlo SS Street Car
|