View Single Post
  #65  
Old 06-09-2018, 08:13 PM
WSSix WSSix is offline
Lateral-g Supporting Member
 
Join Date: Nov 2008
Location: Dunwoody, GA
Posts: 6,287
Thanks: 646
Thanked 569 Times in 463 Posts
Default

So I think I may have fixed the vibration today. I lifted the rear of the trans about half a degree and that seemed to do it. Not sure why as the last time I made an adjustment I had all my angles within spec when I measured without the driveshaft in place. I think the difference may be that I measured with the driveshaft in place this time and that showed that I was a little off from what I measured before. I would have though the measurements with the driveshaft removed would be more accurate since it allowed me access to the tailshaft.

Anyway, I'm going to work on closing the tunnel in now. I'll have to make a new transmission cross brace because the exhaust is almost pinned against it now. No big deal as I have to replace the floor boards too so it'll work out.
__________________
Trey

Current rides: 2000 BMW 540i/6 and 86 C10.

Former ride: 1979 Trans Am WS6: LT1/T56, Kore 3 C5/6 brakes, BMW 18in rims
Reply With Quote
The Following User Says Thank You to WSSix For This Useful Post:
camcojb (06-09-2018)