With the torque boxes installed, I took a break from fabricating and decided to bolt on the remaining DSE front suspensions.
Steering rack out of the box.
Bolted in the frame.
Lower control arms bolted.
Roll bar out of the box and slid into place.
Coil overs out of the box and assembled.
Driver side assembled with the spindle
Pass side.
Shot of the engine compartment with the DSE front suspension.
As usual, the DSE parts are very high quality and fit like a glove. Everything slid into its place. The only gripe I've had so far is their instructions suck. I had to redo several steps, because the instructions were lacking; or spending additional time on extra unesssary steps. But, it was a pleasure to install.