View Single Post
  #4  
Old 10-01-2018, 03:24 AM
jasonz28camaro jasonz28camaro is offline
Member
 
Join Date: Aug 2017
Posts: 94
Thanks: 2
Thanked 6 Times in 5 Posts
Default

First thing I did was remove the DS package tray reinforcement per DSE instructions. This seemed to not be needed but did make it easier to do. I did not remove it on the PS. Then I went on removing the inner wheel well paint to expose the spot welds. Spot welds suck...
[IMG] [/IMG]

Next I cut out the inner wheel well and trunk floor/frame per the DSE instruction and use their template so I could mock up the new tubs





Reply With Quote