CNC Master Cylinder Resavoir. - Lateral-g Forums

1 Dwn Cam · #1 04-07-2008, 03:19 PM

Anybody have a picture of their CNC master cylinder resavoir #1484. I purchased one today and want to see how they look mounted on the firewall. Also do they have a threaded fitting for a AN-4 male feed line?

http://www.cncbrakes.com/acc.asp?grp...rrk&subseries=

1 Dwn Cam · #2 04-09-2008, 10:36 AM

All the bad ass cars on this forum and nobody has one? I find that hard to believe.

1 Dwn Cam · #3 04-09-2008, 05:59 PM

Just got it back from the polishers.

rjsjea · #4 04-09-2008, 06:17 PM

I have the master/clutch cylinders mounted under the dash and have been looking at those to use for a reservoir mounted on the firewall..............not there yet, but I think that will look nice. I also have been lookin at these ones.

1 Dwn Cam · #5 04-10-2008, 12:07 AM

WOW!

Those are way sweet. Who makes those?

rjsjea · #6 04-10-2008, 02:56 PM

www.cvproducts.com part #cvc450. Since I havent bought them yet I would like to know what else is out there......anybody???

tjbruning · #7 04-10-2008, 04:05 PM

Quote:

Originally Posted by rjsjea

www.cvproducts.com part #cvc450. Since I havent bought them yet I would like to know what else is out there......anybody???

rob, I have the printout off cv products website of that very same thing... you have good taste in expensive parts

tilton makes nice resevoirs also...