How do you think a Banks TT would work on this?

[Crowdog]

OK, I've got a SBC on my sand rail:





I'm already running Accel DFI. It has a Dart aluminum race block (going to 410 cid), 4130 forged steel crank, 4340 forged H-beam rods, Dart Pro-1 Aluminum Heads, Stainless roller rockers, Manley 4130 heat treated pushrods
Manley 4130 heat treated pushrods.

About ready to rebuild the engine and thinking turbo. Now's the time to make a decision on pistons & cam. How do you think this setup would work?

No intercooler, 91 octane.

[Steve Chryssos]

Very cool.
Well, it'd make a lot of heat which--can't be good out there in the middle of nowhere. Since you are running aluminum heads AND block, I'd say bump the compression up a point and keep it simple. I'm sure it goes like stink as is.

[slow4dr]

Jon,

You know what I am going to say.