Awsome work!! I remember seeing pics of your excellent pluming some time a go. Can you tell me where did you get the stainless tubing and wich tools did you use ? I know not all benders and flaring tools wont handle stainless .
Awsome work!! I remember seeing pics of your excellent pluming some time a go. Can you tell me where did you get the stainless tubing and wich tools did you use ? I know not all benders and flaring tools wont handle stainless .
The stainless work was done by Nelson and does need tools which most of us dont have
When's it gonna be done? Changing the trans, maybe a week or so?
The camaro will be done by spring the intake has been a lot of work months and months. Once that is complete the rest can be done most of all the little stuff is done fuel,brake,hydro-boost and transmission lines the 80e will take 2-3 weeks to get built and about another week to cut tunnel after i have transmission. Hang in there it will be at the shows next season
Randy
Last edited by 1984 camaro; 11-09-2006 at 08:27 PM.
I can't stop looking at this camaro...Where can I find the overall car specs?
Chevy High Performance will be doing a full artiacle on the car and will cover the entire project.But that is still a few months away. I will post updates as they happen and also check on nelsons site he will have pics of engine and the dyno run later on. The billet intake is the first of its kind and expected to be done in the next few weeks. I will keep you guys up to speed as progress continues
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
1979 Trans-Am Ls1 project
Linear Mode
