how to install crank pulley...more complicated than it sounds....
I picked up a CV Products ex nascar pulley set off ebay. The kind that has a mount for a gilmer style pulley on the front (for dry sump). I'm trying to put it on a small chev. The problem is that I can't figure out the bolt setup. Normally, the bolt goes on the outside of the pulley after you bolt in on right? Well can't do that because of the aditional mount on the front. There is a small recess in the back of the pulley, but not big enough for the big washer that goes on the bolt. Is there a special bolt/washer setup nascar uses? I looked on the ARP website and found nothing. I have seen this setup on sbc's before so I know it can be done.....Any help would be great. Thanks, Jason
|