Quote:
Originally Posted by AtomicFirebird
What is the length of your rearend?
|
Sure, here's the dimensions and specs as they appear on my DSE order ticket:
GM 12-bolt 30-spline Custom Alloy Axle Shafts - 30-spline axles
- Torino Flange / Press on Bearings
- Axle flange OD 5.90" or less
- Axle shaft pilot OD 2.778" or less -1/2"-20 x 3.00" Studs, Press-in
- GM 5 on 4 3/4" bolt circle
- Add access hole to axle flange
- 1/2" Pinion Offset
- "F" Measurement; 25.375"
- "G" Measurement; 24.375"
-Total axle width 54.750"axle flange to axle flange
That's pretty much what your rear end will be if you order their standard config for use with mini tubs, Quadralink, etc. Obviously, they'll make it any dimension you want if you need something different. I toyed with the idea of squeezing 335's back there but I'm glad I didn't, they wouldn't have fit. Since I wasn't repainting the car yet, I didn't want to roll the rear fender lip and risk excessive paint damage and that would be a requirement no doubt for 335's.
The way it is now, I have aprox 1" clearance on the outside and probably about 1.25" on the inside. I haven't measured it for certain but there's plenty of room for travel and lateral tire movement. Hope that helps. If you need anything more specific, let me know and I'll get it for you!