Quote:
Originally Posted by The WidowMaker
your fronts are about the same height as mine, but the edge sits about 1/4" further in (my 9.5x6 bs vs your 8x4.75 bs). im going to have to cut the heck out of the front inners to get them to fit. i thought i would have to do the engine sides, but they have a ton of room. its the outside towards the fender that wont work. i have about 1" of travel before they smack the inners, and thats with the wheels straight. a little cutting a welding should give me 2.5". we'll see.
|
The old Rally setup that was on here was horrible in every way. The fronts rubbed and the rears rubbed constantly until I put those air raid air bags in the rear coils and put a few psi in them.
The new setup the fronts are great, no issues and I dialed down the coil overs quite a bit. The rears have been the pain, lots of trim and trial fit. I think I finally got them cut to where they need to be. I'm glad I had to though in the end because there were some suprises hiding under the wheel well trim. I'm going to have to look into getting both the rears cleaned up and repainted in a couple of spots.