Transmission and motor are in the car being fitted. The transmission tunnel is going to need some massaging. I've included a few pics and you can see in one of them that the transmission crossmember is bolted to the bottom of brackets it should sit on top of, so that tells me the transmission is roughly 1.5: low in the back and also needs to center up.
It even shows up in the shaker angle. Going to have to do some tunnel cutting to get this up high enough. Anyone have driveline angle info or links to some builds that have done this?
Here are a couple of photos from where I am now...
You can see how low the crossmember is here.
and how high the transmission is in the tunnel. The body is setting on Detroit Speed 1/2 height bushings so that makes it a bit tighter.
The cross member should mount on top of the brackets that it is now bolted to the bottom side of. So I need to raise the rear of the transmission approximately 1.5".