...

Go Back   Lateral-g Forums > Technical Discussions > Transmission and Rear End
User Name
Password



Reply
 
Thread Tools Display Modes
  #1  
Old 07-03-2019, 11:26 AM
dukeboy_318 dukeboy_318 is offline
Member
 
Join Date: Sep 2014
Posts: 48
Thanks: 0
Thanked 0 Times in 0 Posts
Default T56

Having a bit of a weird issue.

I picked up an LT1 T56 a while back. Bought the RS Gear LT1/LS1 input and midplate kit to upgrade to fit the LS1 bell. Trans shifted fine on the bench prior. During the swap, the shift rail on the counter shaft, I believe it is the 5/6 shaft, dropped out of the alignment with the guide bolt, allowing the shaft to drop about 1/4 inch to where the shaft wouldn't go into the boss hole in the plate. so on the advice of RS gear, I removed the guide bolt and that allowed me to get the midplate installed correctly. Got it all back together, went to shift it, its stuck in gear. wont go out, I removed the guide pin to see if that would help, it didn't. Any thoughts as to what could be the problem before I completely tear this thing down and rebuild it?
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:53 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
Copyright Lateral-g.net