...

Go Back   Lateral-g Forums > Lateral-G Open Discussions > Project Updates
User Name
Password



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #21  
Old 10-13-2018, 03:57 PM
mfain mfain is offline
Senior Member
 
Join Date: May 2009
Posts: 450
Thanks: 68
Thanked 104 Times in 49 Posts
Default

Quote:
Originally Posted by Flash68 View Post
Hey Pappy, any updates on this?
Motor is finished. Just waiting on the harness for the Motec ECU so I can go to the dyno. Got the Forgeline GA3Rs (18X12 inch front/18X12.5 inch rear) and mounted a set of Hoosier 335/345 scuffs. I went with 8.5 inch backspacing on the front to get .375 inch of scrub (left a little to account for tire squirm under load), and everything cleared including the inner inside of the barrel (control arms, tie rod, sway bar, etc.) and the tire thru full suspension travel up to 30 degrees of turn. Whew. I've still got to move the firewall and motor back 5 more inches to get the dry sump pump to clear the aft pick-up point of the lower control arm. With the smaller Tilton bellhousing I will also be able to lower the motor another inch or more. I also got the Tilton 900-series pedals so I will complete their installation when I move the firewall. Still lots to do, but getting there.

Pappy

Name:  56 Corvette Forgelines Front 3.jpg
Views: 0
Size:  73.2 KB

Name:  56 Corvette Forgelines Front 4.jpg
Views: 0
Size:  62.4 KB

Name:  56 Corvette Forgeline Rear.jpg
Views: 0
Size:  79.2 KB

Name:  56 Corvette Tilton Pedals.jpg
Views: 0
Size:  69.1 KB
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:18 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright Lateral-g.net