Quote:
Originally Posted by jarhead
looking good Chief!
|
Thanks Joe, one thing at a time right? Been trying to warm up the garage a bit to work, waiting on some 20 ga TXL wire for my harness I have to make to integrate my IQ3 Street dash to the GM harness.
Since I mounted the relay box where I did I have to extend the IQ3 harness about 4 feet.
Waiting on my through bulkhead connector for power and working on a mount for my AAW fuse box for the dash area -- never ends!!!
I did drill a hole in the tunnel area for a pass-through grommet and finished wiring my Entropy fan controller, just need to wire it up the GM harness, yeah!
Had to remove about 18 inches from the harness to make it neat and tidy!
This looks good ... didn't care for the BIG HOLE in the dash look ...the GM harness stuff will come through the side tulip panel!
Working on the wiring harness for the incorporation of the IQ3 dash into the GM harness and user indications (turn signals, hi beams, whether I'm being followed, ect,) and planning the routing of said stuff to look right ...
Thanks for looking ...