Today I made up a floor mount for the DBW and then made a bracket for the ECU. I have to wait to get my gauges in so I can make sure the ECU location works. If its good clearance wise I am thinking of just welding it to the cowl
Not a lot of room with the AC ducts right there....
Took the day off.. got a good amount done... started with wiring made a lot of progress then decided to make some changes that require weatherpack connectors I dont have... (if anyone now a good source let me know)
Got the clutch master hooked up. I took a slightly different approach. I shortened the rod on both sides, then drilled into the fat end and ran a tap into it. Then ran a Die over the small end. this gives me about .5 to 1 inch adjustment.
started on my gauge panel.. too some 3" exhaust pipe slash cut them @45 degrees this is a rough in it will be much better fitted into the dash before its done. hoping for a factory look when its done.
completed my wiring on the bench.. now time to MOC it into the car. Fist step Batt.... (BTW Optima no stickers with a new Battery? ) the cutoff is removable goes through the lower bolt hole of the bumper for track days.