Bulkhead connectors

[IndyNova]

Hey guys, finally got my 6.0 ls motor installed in the nova , and I want to split the engine harness and install a bulkhead type connector so I only have to drill one hole in my firewall to route wires through. My problem is finding what I need. Any ideas on where I can find them at? Or, if anyone has a better idea of how to achieve this, i would appreciate any advice. Thanks

[snappytravis]

I bought a big two piece grommet from summit. I plan to drill a big hole in the center of the firewall then run my ecu wires through it. Then install the grommet.


Like this
http://www.summitracing.com/parts/SIT-SGS3-5-BL?seid=srese2

Just another idea for you, Good luck

[raustinss]

Molex, Delphi, metri....they all make bulkhead type connectors that you may want. I believe that DSE sells some and possibly ring brothers...or fesler
Good luck Ryan Austin

[GregWeld]

Hey guys, finally got my 6.0 ls motor installed in the nova , and I want to split the engine harness and install a bulkhead type connector so I only have to drill one hole in my firewall to route wires through. My problem is finding what I need. Any ideas on where I can find them at? Or, if anyone has a better idea of how to achieve this, i would appreciate any advice. Thanks




Call Rodger @ Ironworks.... he uses "mil-spec" bulkhead connectors that are pretty slick.

[ironworks]

Call Rodger @ Ironworks.... he uses "mil-spec" bulkhead connectors that are pretty slick.

Thanks Greg - They are on our website.