PDA

View Full Version : Wire Cover or Sleeve

96z28ss
06-16-2015, 12:37 AM
Wire cover or looms or sleeves not sure what you call it.

Where can I get this stuff, Who makes it? Are other color combinations availiable?
Schwartz Perf
06-16-2015, 08:44 AM
I haven't seen that exact stuff before.. but WireCare.com has a lot of sleeve products, most are made by TechFlex

-Dale
lsuguy
06-16-2015, 08:47 AM
I plan to use Techflex when I get around to wiring. If you look for Furry Letters store on ebay the guy sells just about every size/color by the foot.
waynieZ
06-16-2015, 11:25 AM
I got some from here, but I have seen the exact one your showing, somewhere on line.
http://www.ebay.com/sch/furryletters/m.html?item=231308514530&ssPageName=STRK%3AMESINDXX%3AIT&rt=nc&_trksid=p2047675.l2562
MtotheIKEo
06-16-2015, 01:56 PM
Waytek has you covered if you want black
http://www.waytekwire.com/products/1468/Braided-Sleeving/&pageSize=36

They also have heat shrink cable sleeves in black as well
http://www.waytekwire.com/products/1380/Fabric-Sleeving/
no go nova
06-16-2015, 10:15 PM
Whats that paint on that block and trans?
96z28ss
06-17-2015, 05:22 PM
Is it wire inside a hose?
Schwartz Perf
06-18-2015, 09:01 AM
It does look like AN hose more than anything. Could very well be I suppose....

-Dale
69hugger
06-21-2015, 10:18 AM
It IS hose. The OP picture is from the Angelo Vespi/ DSE Camaro. I had some of the same hose on my car (DSE worked on my car too). I shortened a piece of it...it is cloth braiding over a lightly convoluted inner plastic liner. Just cuts with a sharp scissor. In my case it has A/N style 2 piece fittings. It is easy to work with...much more than SS braided hose.
I like it with the shrink tube for cable cover. Slick...
This is a pic of the hose used for my fuel tank breather.

http://i1113.photobucket.com/albums/k513/bsternz06/DSCN4525_1.jpg

Summit has it with a blue or red tracer. Not sure where to get it with the gold tracer. I wonder if DSE would divulge?

I hope that helps.


Bill
rallystyle
06-21-2015, 02:21 PM
69hugger that hose in your pic is goodridge ptfe hose 910 i think.

96z28ss i think dse just pulled some of the covering from the goodridge hose to cover the wires to make it all match.

I use techflex for covering my harness and it looks good. dont think i would want it that close to my exhaust as it might melt. wirecare and amazon are good places to get tech flex from.