OK, that's just not fair!

What a score. :thumbsup:

You can find lots
 

of stuff on www.racingjunk.com That is where I got this block.

Payton between you
 

And Dave there's probably nothing good left on there! Definitely love the direction your going, Keep it up:thumbsup: :thumbsup:
Shane

Chubby!!
 

My car, which does not have a name, sorry Payton.... was highly insulted by the chubby comment. Luxury, plump is fine.. Beauty, driving and speed balance is reasonable...

Looking good Payton, that frame is one sweet piece, can't wait to see when they start on the body, low and wide, will be killer!

Southern slam
 

Nice to meet you this weekend Payton, and listen to Ron tell stories of course :lmao:
Hope you had a safe trip back home.

really like the direction you are moving in this build is going to be a nice one:thumbsup:

Good to see you too Aaron
 

Been crazy busy with going to the Southern Slam in Kershaw and trying to wrap up both of my boys soccer season that will never end.

Ed, the engine builder, has been slowly coming up more and more great scores. He found a set of 6.2 Pankl rods with just a couple of dyno pulls on them. Apparently Roush was doing some rod/stoke testing and made 3 pulls, changed the combination and like what they found. He also found the fittings we need to use with the oil pan I picked up.

http://i1138.photobucket.com/albums/...ps11db95ce.jpg

These rods have a hole laser drilled up the center to oil the wrist pin. The dry sumps were pulling so much vaccum that is was sucking the oil out of the wrist pin and causing motors to blow up.

http://i1138.photobucket.com/albums/...psfbe16cdd.jpg

Nice block there mister!!! I have block envy now.... Holy cow.

Thanks Greg
 

wait till you see my oil pan...top notch fab work.