Couldn't be much.. I will find how many tubes we went through and how much each tube's volume weighs.. It's not super thick and heavy like Line-X. I will also get the exact name of the stuff.

What product is it?

It looks like Wurth, a water based under coating that Mercedes uses. Are you going to install the subframe conectors on Monday when you put the frame in .

Not sure.. might be another week before the subframes go in.. I am still wrapping my mind around how they mount.. lol.. Once I get the subframe in it will be easier to see where they need to weld.

The subframe is damn nice.. I can't wait to get it in.

I will get you guys the brand of the undercoat asap..

I can send you some pictures of the bottom side of our convertible if you want. let me know and will take some pictures tomorrow.

That would be great.. just not sure of how the back attaches.

you have my email.. right? if not Ed has it. Thanks!

My Duplicolor Bedliner Coating arrived today. It comes with a special gun to spray it on that hooks up to an air compressor. Seems pretty straight forward. Sounds a lot like what you've got on Penny.

Most likely the same concept.. but it was a name I hadn't heard before. I will drop by the shop tomorrow and get the actual name

I finally got that info on the stuff we used for the underside..

FUSER – Wheelhouse textured coating and sealer .. part number 805

7 tubes weigh about 5lbs.. Once the solvents evap away I bet it only added three-four pounds to the car. The finish is slighly rubbery, good for rocks.

Hope this helps..

Steve, have you already coated your pulleys? I recall you metioning you were looking into powdercoating or anodizing.