Yeah that lean in is a sweet idea. :RunninDog:

Sneaking up on the design. I think we are going to ad just a bit of curve to the panel. Then I need to figure out how or what we are going to put in the tail panel for to fill that broad flat spot. It looks too much like Nebraska currently.

http://i616.photobucket.com/albums/t...13-2013014.jpg


Believe it or not the top of the rear bumper is not flat. So we did some surgery to flatten out the peak in the rear bumper. I think we will cut the tacks and narrow the bumper further.
http://i616.photobucket.com/albums/t...-2013015-1.jpg

Will you be adding a gas filler cap in the panel?



--Eric

That is the direction currently.

Why does everyone always refer to Nebraska as being flat. What about northern Oklahoma? ;)

Or even central Wyoming? Break the stereotype! :D

Awesome work guys. Love it as usual! :thumbsup:

Thanks guys, I drove all the way across Nebraska a few years ago and its flatter than a board.

We thank you for spilling all that diesel fuel as well....LOL We do have a few hills they just aren't around the river where the Interstate is so you need to add a few bumps to that panel. ;)

Yes,right in the center,also wanting to put a billet piece across the back,something similar to the stock SS molding,maybe instead of SS it may read ZL1:thumbsup:

Progress

http://i616.photobucket.com/albums/t...-8-2013019.jpg
http://i616.photobucket.com/albums/t...-8-2013018.jpg
http://i616.photobucket.com/albums/t...-8-2013021.jpg
http://i616.photobucket.com/albums/t...-8-2013023.jpg

Time to narrow the bumper, and get the side profile of the spoiler set up. The figure out how to get the trunk to open and close smoothly. HMMM