PSI Harness. Fuel Pump relay gets 12V from the ECM when Ign is turned on.

So are you saying you don't have 12 on the wire that goes from the relay to the pump?

No Power so its mailed back out to Gary @ PSI

He said he would get it fixed and set back to me. Ill get there soon

Before you send it back to PSI, just be aware that the ECU shuts off the power to the fuel pump after 5 s (I think) if the engine is not running. Not sure if you know that or not.

It use to do that now it does t have any power coming from the ECU.

Back at it....

ECU Re Programmed everything seems like it should run. It wants to start but just wont fire.

My fuel pressure is only at 50 PSI could that be too low?

It should start and run just fine with 50 PSI

Make sure you have 12v going to red ignition wire with "key on & cranking".

The wire I fed it with had power with key key on only, but nothing when cranking. It would turn over, but not fire up. It's a fairly common issue (sorry if you have already checked this).

So my new Vaporworks tanks in. I hooked up a scanner to the car and its throwing a P0135 code. The scanner says Crank sensor but I changed it. Online forums says o2 sensor. Hmmmm

Does it start and run now?

Car will still run with the P0135 code. In fact it should start and run even if the O2 sensors are not installed.

No start it wants to start it sounds like but nothing