All of the wires neatly run under the manifold.

http://www.syborgtwinturbo.com/album...9_07_KD_15.jpg

All that is left is to shrink wrap the all of the fitting to keep the colors dark.

http://www.syborgtwinturbo.com/album...9_07_KD_17.jpg

Once again I owe Big Al big for helping us out.

so i see you cut the rear cover off the manifold... why did you do this marty, plus the wiring is seriously clean.

It just didn't look right - so off it went.

Next time were going to make it out of chipboard

Good Afternoon all,

Plumbing the AC Lines is complete.

http://www.syborgtwinturbo.com/album..._05_KD_013.jpg

The lines will be clamped together with a couple Billet Specialties Line Clamps
and then anchored to the inner fender.

http://www.syborgtwinturbo.com/album..._05_KD_016.jpg

Kenny had to do a little trimming on the Billet Specialties lower bracket to install the crank trigger.

http://www.syborgtwinturbo.com/album...09_06_KD_4.jpg

Sorry Mike - this is the best picture I have of the Crank trigger installed.

http://www.syborgtwinturbo.com/album...09_06_KD_8.jpg

Looking great!!!!!


--Eric

Looking sweet!!
Can you tell me where to get that back space tool.

Looking great as usual Marty!
How much longer before you can drive it :cheers:

You used to be able to get it from a company called Wheel Tech.

I do loan / rent it out if you need to use one. Plus there expensive as all get out.

Well with winter just around the corner it won't be driving this year. But it will be running pretty soon.

Just Haul it down to me in Arizona we can drive it all year long

Tonny