lateral-g

Looks great Brett! :thumbsup: Thanks for posting and seeya next week :) :cheers:

Ron, you're one lucky bastard. Your car is getting top notch, royal treatment. Just so you know, I'm stealing all of you and Brett's tricks, like the little bracket-holder-thingy on the gas tank. Dead Pool is looking real nice right about now.:hail: :hail:

Now that you're writing about fuel tanks, this is perfect time for me to say that my Fab 53 VaporWorx tank is great. I tested it last week and it worked just as it was supposed to, no leaks, etc. The workmanship on it isn't half bad either. :lol:

Thanks Brett!

Quick?? I can only imagen if you took your time on that bracket how much better it would look :P

lateral-g

lateral-g

Rear close-out panels by Fab53
 

lateral-g

Nice fabrication work Brett. I like your standoff bracket and the initial feed line. I can't express how important it is to exercise proper fuel outlet strain relief, especially on the CTS-V fuel module. I've had two customers break the outlet, one of them twice. I managed to fix them, but it's not inexpensive or quickly done.

Thanks for the feedback on the wiring harnesses. The VaporWorx harnesses are quite a bit different than others out there. They are more expensive, but have features such as a two-piece design, fully wrapped, Delphi interconnecting plug, integrated fuel level sensor wiring, etc. They are pretty close to being plug-and-play (pun intended.)

Brett,

There's gotta be some software that automatically enables your build posts to become part of a sticky. :unibrow: