It looks nice.

The fuel lines and filter are attached to the subframe connector

http://img.photobucket.com/albums/v3...ps1ba786f9.jpg

http://img.photobucket.com/albums/v3...ps81a2004e.jpg

They go through the torque box and into the engine compartment

http://img.photobucket.com/albums/v3...ps36d2d9d3.jpg

I forgot to show this but awhile back Mark Houlahan came by the shop to help us install the Ron Francis wiring harness for the SOHC Mod motor.

http://img.photobucket.com/albums/v3...psaa5804c7.jpg

http://img.photobucket.com/albums/v3...ps53186c2f.jpg

We are not finished under the hood

http://img.photobucket.com/albums/v3...psc49a0ca9.jpg

Brian was helping Mark

http://img.photobucket.com/albums/v3...ps2e237c1c.jpg

Takes a lot of wires to run a modern engine

http://img.photobucket.com/albums/v3...psc9dc5c4a.jpg

http://img.photobucket.com/albums/v3...ps06a744e3.jpg

Every wire is numbered so you can't make a mistake if you hook it up to the same number on the control panel that is plugged into the stock Ford computer.

Brian and I were trying to figure out what we were going to do to cover up all the wires in the trunk and we found out about Mustang to Fear's trunk kit for the coupe. At the time we inquired they only had one made for the Eleanor style taillights. Rich said he was going to make one for the stock taillights and we also received the first gas filler neck cover.

http://img.photobucket.com/albums/v3...pslaqvd0pz.jpg

http://img.photobucket.com/albums/v3...pskfopjnj5.jpg

We still have to make a bracket to mount the computer and control panel behind the the Mustang to Fear trunk panel kit.

You can read all about the install How to Finish Off Your 1967-1968 Mustang?s Trunk

That's Nice Rusty!

Nicely done, Rusty!

Very Nice.

Rusty,
Now that you have used Lizard Skin, and SPI bed liner, do you have a preference?

Thanks, Joe

Any chance you have a rear tailpipe laying around? i heard that the mustang tailpipes work with a 1st gen camaro with dse quadralink

No question SPI bedliner but they quit making it.