lol i could only sit in there welding for so long before i got too bored to do anymore. the other side is welded now but i haven't ground it down yet. figured i do it when i grind the 3rd link cover.

thank you.:thumbsup:

been pretty busy so i haven't gotten a lot of time to work on the car. i did get the other muffler done so that makes 2.
http://a7.sphotos.ak.fbcdn.net/hphot..._7105144_n.jpg

and the fuel cell done.
mocked in the cage to check fitment and measure for the fill panel i needed to make.
http://a1.sphotos.ak.fbcdn.net/hphot..._4350807_n.jpg

needed to cut the stock fill hump shorter and fill it back in.
http://a3.sphotos.ak.fbcdn.net/hphot..._3957016_n.jpg

then using 3M 8115 panel bond adhesive i mounted the cage to the car. it holds the cage in as well as doubling as a seam sealer. its also welded in a few places and will also be tied to the frame and cage.
http://a7.sphotos.ak.fbcdn.net/hphot..._1683098_n.jpg

after it dried i put the cell in.
http://a6.sphotos.ak.fbcdn.net/hphot..._3715992_n.jpg

at the lowest point its 8". thats more than i had in my '67 and there has never been a clearance issue with that car.
http://a5.sphotos.ak.fbcdn.net/hphot..._1164646_n.jpg

Wow!! That look's great.Will the tank have a EFI pump in the tank or outside.:thumbsup: Scott M.

pump inside, i'm planning on 4-6 pick ups so i don't have to put in a trap. its the same pump i had in my other car. its been in that car since '06 with zero issues so i feel really good about using it again.

http://www.jegs.com/p/Aeromotive/Aer...50904/10002/-1

been busy and haven't had a lot of time to work on the car. i did finish the the 3rd link cover today though.

http://a6.sphotos.ak.fbcdn.net/hphot..._7380777_n.jpg
http://a8.sphotos.ak.fbcdn.net/hphot...3_215239_n.jpg
http://a2.sphotos.ak.fbcdn.net/hphot..._4436212_n.jpg
http://a1.sphotos.ak.fbcdn.net/hphot..._5397834_n.jpg
http://a8.sphotos.ak.fbcdn.net/hphot..._6022173_n.jpg

lots of welding and grinding all day. it sucked but now i have to grind the bottom which will suck even more. i might just wait on that until i get it on a rotisserie.

greg, i finished grinding and smoothing the other side.:lol:

Lookin great as alway's.Really going to have a great ride when your finished.:thumbsup:

I've been following your build for a while now. This is going to be one bad car, it looks awesome.

thanks guys, looking forward to driving it more than anything.

Where are the mufflers going to sit?

not sure yet. i want to try and put them on either side of the fuel cell. if not then they do fit in the stock location (already checked fitment)