thank you sir!!


Yes, rust is a must to stop. :welder:

Great build. Hopefully will get to see this car on the road soon since I too am in the Bay Area.

What Airaid u-build did you use? I don't really like the Spectre CAI so will probably go with this instead.

Also I noticed you used the Dirty Dingo alt/ps bracket, but did you use the stock ps pulley? How is the fittment? I'm just curious because I have the very same bracket but have not gotten to that point yet.

Hi Spec,

Cool, good to see locals on the forums.

We used the Airaid multi bend tube and made everything else from off the shelf parts.

The DD bracket is OK...the PS pump could have been clocked a little different to work better. Stock pulley from the GTO LS2.

Bump. Lol!:gitrdun:

I know, I got so many damn pictures I don't know where to start....

So we:
Located the controllers
made mounting brackets and tabs
modified the seats and made floor mounts
made brackets for the shifter linkage and cable
finished up the sheetmetal work on the floor
primed and painted the foor and now getting through the dynamating
still working on the center console mounting brackets

Closed up the ash tray and a/c controls

http://i122.photobucket.com/albums/o...ps06930212.jpg

Lots of test fitting going on, Its progressing well though.

http://i122.photobucket.com/albums/o...psefc772c0.jpg

what steering wheel is that and size?

The complete setup came from Ididit, it's a 13.75 inch wheel.

who makes the HID's you put in the chevelle ?