worked on the toe board a little today. the 2x4's were used to space it off the table so I could deepen the arc a little. The sharp bends were done using a brake and the initial arc was done by hand.

http://www.hemiswap.com/dodge_1941_05.jpg

http://www.hemiswap.com/dodge_1941_04.jpg

http://www.hemiswap.com/dodge_1941_03.jpg

http://www.hemiswap.com/dodge_1941_02.jpg

http://www.hemiswap.com/dodge_1941_01.jpg

made the firewall notch today

http://www.hemiswap.com/1941_dodge_pickup_floor04.jpg

Good idea! It looks good.

trimmed the old firewall piece to fit



http://www.hemiswap.com/1941_dodge_truck-004.JPG

http://www.hemiswap.com/1941_dodge_truck-005.JPG

http://www.hemiswap.com/1941_dodge_truck-006.JPG

Firewall mostly welded. I filled 32 holes too.

http://www.hemiswap.com/1941_dodge_truck-firewall.JPG

Made the final piece for the trans hump. Just need to trim the hole in the floor , then weld it in

http://www.hemiswap.com/1941_dodge_truck_floor01.JPG

http://www.hemiswap.com/1941_dodge_truck_floor02.JPG

Glad you're still plugging away at it. I really like alternative builds.

Nice to see an update. Looking good.

one eternity later....

dyno:



walkaround:



boost with no traction:



light throttle data log drive:

Looks cool. Enjoy it a little bit before you blow it apart for paint.