Exhaust looks awesome

Tell me more about the tubing tim used..... I know he uses food grade ss. Alot of you curved pipes look like one continous piece... Like over you axle.... I assume that tim's awesome welding and finishing rather than one true pipe section with all those curves. There looks like there is a welded in piece right before the x pipe that wasn't metal finished, so I was just wondering

Looks awesome

from the muffler, over the axle is 4 or 5 pieces I think.
There is alot to go around with the quadra link.

paint it already! :P

Oregon resident too huh? Looks great. Love the back end, and those front inners, nice job.

Here is a small update on the engine compartment.

Here is a fan shroud that I had laser cut, and then Tim bent the ends up and welded to the radiator. They are Spal fans and should pull alot of hot air.

http://www.automotivedesigneng.com/g...amaro/fans.jpg

I had Tim straighten the radiator support. By straightening it we gained over an inch for the intake on the supercharger.
Also made mounts for the intercooler.

http://www.automotivedesigneng.com/g...o/DSC05980.jpg

Since the radiator support was made straight the hood latch is going to get modified. I also made a new front end support and had it laser cut.

http://www.automotivedesigneng.com/g...o/DSC05975.jpg

All the intercooler plumbing is now done and it looks real good. Tim is real good at laying stuff out, making sure stuff is symmetrical.

http://www.automotivedesigneng.com/g...o/DSC05973.jpg

This is why I have two different size fans. The intake on the supercharger needs to go somewhere.

http://www.automotivedesigneng.com/g...o/DSC05978.jpg

as usual more updates later...

:theresa: :theresa: :hail: :hail: :thumbsup: :thumbsup: :woot:

Gitter dun Bob!:woot:

It looks good.

Very nice.

Saw the Camaro on Sunday.....looks better in person. Very cool;)