more stainless
 

Still working on the turbo headers, will move into the plumbing and controls soon.
A few pics:
http://www.daemoncustomauto.com/P180...20d%20side.jpg

Drivers side, I am mounting the turbo's back near the firewall, the headers ended up looking like ram horns. The engine bay is tight so this is where I found room.

http://www.daemoncustomauto.com/P180...nt%20dside.jpg
I am supporting the header near the turbo with a support welded to the bottom and bolted to the block, also have hangars for the turbo that are not mounted yet.

http://www.daemoncustomauto.com/P180...transition.jpg

http://www.daemoncustomauto.com/P180...0collector.jpg
my welds are more consistent now, stainless is nice to work with.

Its been a while since i have been on here. Pretty awesome stuff!

Headers look fantastic!

handle mod
 

I have removed all the mechanical bits from the door handles and am replacing it with electronics. I modified the door handles to accept the illuminated buttons that actuate the door latches.

http://www.daemoncustomauto.com/P180...s/DSCF1688.JPG

http://www.daemoncustomauto.com/P180...s/DSCF1692.JPG

http://www.daemoncustomauto.com/P180...ndle%20mod.jpg
This last image was a test fit before all the machining was complete.

That's a neat idea! :thumbsup:

Great idea with the door handles. Will they work with a proximity key to allow activation?

Thanks, and yes they exterior release is only active when the alarm is deactivated. It could work the same way with a prox key

cooling and pedal
 

Slowly putting together the firewall and planning plumbing.

Rad in:
http://www.daemoncustomauto.com/P180...20radiator.jpg

Wilwood Pedals test fit:
http://www.daemoncustomauto.com/P180...T%20pedals.jpg

And some eye candy under the hood:
http://www.daemoncustomauto.com/P180...0reservior.jpg

Lookin Good.!!!!!!:thumbsup:

Getting closer now. Looks great!