I got back on the project today and finished the inlet tube with the Mass Airflow sensor mount.....Test fit and ready to go.....I just need to add a fitting for the valve covers venting into the tube.......I'll do that tomorrow and another thing off the list....


http://i13.photobucket.com/albums/a2...132701E395.jpg


http://i13.photobucket.com/albums/a2...2DA67E143B.jpg


http://i13.photobucket.com/albums/a2...4F14F6221C.jpg


http://i13.photobucket.com/albums/a2...3610002E54.jpg

Got the air intake tube finished up today........After looking at the way that GM engineered the fitting that connected to the valve cover vents to the inlet tube........It seemed to me it was like a mini chamber so any residual anything would go to the bottom of the vessel......so......I made a mini version out of aluminum for the Vapor to flow thru, I probably made it more complicated than it needed to be ......but.......What's new.....LOL....


http://i13.photobucket.com/albums/a2...91BA187826.jpg


http://i13.photobucket.com/albums/a2...693A71203C.jpg


http://i13.photobucket.com/albums/a2...8F47A95815.jpg


http://i13.photobucket.com/albums/a2...691308D10D.jpg

Well..........Can't put it off any longer......I bought an American Autowire Classic kit....Nice kit but they provide for every conceivable option and variable......so....I have probably 1/2 the wires that aren't going to be used ,.....so.....I have to sort all that stuff out.....First picture is what I started with this AM............the other pic is later in the day.....should have it pretty much sorted out and neatened up in a couple more hours......,.So far.....everything works like it should........LOL


http://i13.photobucket.com/albums/a2...E183E1E2FF.jpg


http://i13.photobucket.com/albums/a2...A602A9CAF4.jpg

Making a little progress every day.....I have pretty much all the basic wiring in place and fit.....all the loose wires you see left are mostly for all the Dakota Digital senders and sensors.......Looks like a lot but its only a couple of hours to get everything cut, fit and installed.........


http://i13.photobucket.com/albums/a2...6FB8E84A95.jpg


http://i13.photobucket.com/albums/a2...3543F92C54.jpg


http://i13.photobucket.com/albums/a2...8AFED5AE71.jpg


http://i13.photobucket.com/albums/a2...4746D7C909.jpg

Looking good Ken
 

Nice attention to detail and very neat. Do you create a schematic of sorts when your done or just rely on all the old instructions from various parts purchased and installed? I wish there was a neat way to label everything.

The one neat thing about the AA kit is every wire has printing on it for it's purpose.......makes it so simple even I can do it......LOL......"NOT"

Whats the GM part number for this? Thanks.

Here you go #19166574

Thank you sir. Beautiful work btw.

make sure you weld it on or put a gasket under it. I have had them leak and cause tuning issues giving erratic a/f maps