The tunnel in my car is raised about 4 inches
 

and I am running a T56, so the shifer is too far back. I could not think of a way to make the stock one work with the center hand brake either.

Yes, those are Arizen seats and I feel are a great seat for the money and the lowest seat height I could find.

Looking good Payton. I like the console and shifter boot area. Nice car. See you at SEMA.

Thanks guys!
 

I am pretty excited about right now!

Stuart looking forward to seeing you as well.

Kevin, I will be up in your area next week. Taking it to Nick Williams shop to run it on the dyno. I will try and stop by your work on the way.

I am not sure about other Vintage Air units, but I have Gen II super cooler and it recycles cabin air. They even give you a plastic cover plate to block off the cowl vent on the passenger side.

Very nice! I am planning the same set up on the dash insert. Console area turned out nice. Can't wait to get to your point in my build.

It's obvious why you are happy with it! They did a great job. Really fits the whole car. Nice to see a plan finally come together the way you wanted, huh? Nice job Payton. :thumbsup:


Brent

Great interior Payton!

Very nice to see an interior not looking like it´s taken straight out of a 90´s pro-street car with flames and bowties all over....

:thumbsup:

Alex

It pulled off damn well to say the least. I envy you guys with hard tops that can run: recaro's,cobras, corbeaus,etc .

I have to just run low back buckets with 5 points so I dont look like a idiot.

Looks Great Payton!! :thumbsup:

I love it Payton, looks very clean and like it belongs in a 69 Camaro.

Jody

Wow!! Payton that interior is way cool. Great Car and owner!! Hope you can come thru town again.