Originally Posted by NOVA (Post 164416)

I am curious about this as well, the centers (inside the black, looks like satin finish?) apparently that is the silver powder coat, therefore makes it two tone??

Originally Posted by sacarguy (Post 164504)

This is the wheel i plan to put on my car

but i want the centers anoodized in the smoke titanium before the slots and bolt area is machined so what you would have is smoked titanium annodized where this wheel is black plus the silver machined inlay along with a brushed and cleared lip

Originally Posted by NOVA (Post 164416)

I am curious about this as well, the centers (inside the black, looks like satin finish?) apparently that is the silver powder coat, therefore makes it two tone??

Originally Posted by thedugan (Post 164513)

Cool -

Do I get royalties on the design?

Originally Posted by sacarguy (Post 164504)

i want the centers anoodized in the smoke titanium before the slots and bolt area is machined so what you would have is smoked titanium annodized where this wheel is black plus the silver machined inlay along with a brushed and cleared lip

Originally Posted by JayR (Post 164550)

What you see is the brushed aluminum, not silver powdercoat. After the pockets and sides were machined, the whole center was powdercoated clear to protect the brushed aluminum and to seal all the black edges.

Originally Posted by 1960LesPaul (Post 164925)

Those are effing sweet looking. Man I wish I could see them on my black Chevelle. Jon I should be calling you in the next few days for those Varishocks. I already have all my other parts.

Originally Posted by DriverzInc (Post 164357)

Thanks John. These are going on a customer's black camaro. They are going to set that car off!