You can also check out Kwik Performance. They were recommended to me by BRP when I bought my LS1 conversion kit.

http://www.kwikperf.com/

Does anyone make an installation kit (motor mounts, brackets, etc) to install an LS? into a 2nd Gen F-Body? Is there an easier model to install for example LS1 vs LS2 or LS3? I might be trading for an early model 70's Camaro that is really nice but I would like to do a LS? w/ T-56 swap. I have been reading up on all this stuff but I can't find if there is an easier model to install or are they all the same? I was also looking at a 6.0L truck motor to swap. Are these along the same lines as the others to put in a 2nd Gen? Sorry for all the questions, but this is how I learned so much about Foxbody Mustangs. Thanks for any info you can give me.

http://www.brphotrods.com/mm5/mercha...gory_Code=CNV2

this is where i purchased my kit for my 69. i had to notch. i am not sure on the 70 but look at the link. i run a factory corvette drive system w/ac mounted in factory location.

hey Kenny.............. looks like ur scre%%$ed
:willy: