Lateral-g Forums - Ignition wires touching headers on LS

Page 2 of 2

Show 40 post(s) from this thread on one page

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)

- LSX Conversions (https://www.lateral-g.net/forums/forumdisplay.php?f=70)

- - Ignition wires touching headers on LS (https://www.lateral-g.net/forums/showthread.php?t=39081)

cheezer

11-14-2012 04:03 AM

Quote:

Originally Posted by camcojb (Post 446193)

I used aftermarket wires with 90 degree plug boots. They have a lot more room than the factory wires do.

I just ordered the MSD wires yesterday.

Once again, thanks for the input.

cheezer

andrew69_04

11-14-2012 01:08 PM

I ran into that same issue with a set of SW headers on a 2006 GTO. The MSD wires will fix your problem since the boots are bendable so you can make them fit how you want. should fix your issue

CarlC

11-14-2012 03:14 PM

Had exactly the same problem. I ended up using the stock wire but used these http://www.kingsbornewires.com/produ...&categoryId=98

They fit perfectly and for $3.50 each it's a deal if you already have a set of wires.

gray86hatch

11-20-2012 05:24 PM

Good luck with the MSD. The boots are cheap. They don't snap on the plug after removing them a couple times.

If you take the heat shield off the stock wires you can bend them just a little to clear the header.

If you are buying new wires get a custom set from FIRECORE50. They are the best wires I have ever had on my car.

Tim

All times are GMT -7. The time now is 02:09 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page