I just ordered a stealth tank from Ricks. They mentioned your car when I told them mine also had a quadralink in it. Thanks for doing the test fitting, I hope mine works right off the bat.

Sweet car too, when I need motivation I check out your site. :thumbsup:

thats just 2.5 pipe. thanks for the compliments. soon it will be finished

Can you fit larger pipes? What's the limiting factor? Is that a custom system, or a kit?

Sweet ride, really sweet, you guys are doing some very nice work. I'd love to see some in person, any chance you guys will have a car at SEMA this year?

Mark

Looks great!
 

I am doing the same basic setup on my car Quadralink, 335s, etc.. I was hoping to use a 3 inch Flowmaster American Thunder kit on mine. I guess this will not work. Should I be planning to have someone custom bend the whole thing? Where did you get those tips?

Your project has also been a major inspiration for me.

-Tracy

Full on Chubby here. Very nice work!!

Jason,

I take it your exhaust is stainless? Correct? There is a much less expensive and better way to go then jet coating the exhaust. I had mine electroplated for $100. All I had to do was sand down exhaust with 220 grit paper. We compared my finished exhaust to polished stainless that others had done. My stuff came out on top at a fraction of the cost. FYI


R.P.

I love how that turned out who did it? do you have a # Thanks

-Paul :thumbsup:

thanks for the tip roger but actually its not stainless. I am running out of time and could not get it in stainless at the time. this is why i considered the jet hot option. this might all be changed after the powertour .

Call Jerry at Detroit Industrial 313.3925.4454

R.P.

My two cents worth. Why spend the money on jet hot. Let it go as is until after the tour. I'm sure you had to use regular steel for a mock up anyways.

R.P.