Round 2 - Including rear concepts

Brushed Bumper - with dark grille surround
Attachment 47538

Dark Bumpers
Attachment 47539

Ben added a colour coded bumper version
Attachment 47540

I had Ben do a revision to Brushed Bumper, adding dark tail panel & different exhaust exit treatment

Attachment 47542

After much feedback, all very positive, I decided to move forward with Concept 1A, much as I liked them all I felt this was nicer balance. I really liked black bar front, not so much back, opposite for color coded version (and Greg Weld liked it best :D ). But I will seriously consider doing 3 different sets of bumpers to trial on car when the time comes.

Had Ben do another update, put Grip Rebel rims on Concept 1, pulled Z28 stripes back to factory position, moved vents forward, color coded door handles, so this is now "final" rendering.

Attachment 47543

Ben has been great to work with, highly recommend him to anyone thinking of getting a rendering done

I like the way the hood looks better this way. I like the vents going closer to the nose and the factory stripes look better not so far up in the nose imo. Looks great.

And i'm also with you on the rear bumpers, i'm leaning towards colored, but the jury's still out....going be a fun build to watch. 68's 69's and 70's are my favorite F body's

The journey begins. Rusty cowl out, front floor plans out. Started on removing quarters.
Good news, no more ugly found. Once rusty bits are all removed, car will be media blasted again and then primed. Good opportunity to get to some unreachable places to give a protective coating

Attachment 47859

Attachment 47860

Attachment 47861

Attachment 47862

Attachment 47863

Next container with parts due here May 21, but plenty to do till then

I love the exhaust on this one and when it moves around it won't rattle on the car.

Plus it looks bad ass

Good luck! It's going to look great when finished.

Well we did find some fugly. When they modded the quarters they also hacked in to the trunk drop offs. But as was commented they did such a good job with the fibreglass it was hard to tell until quarter panel was unpicked. The evidence of how much was hacked off

Attachment 48244

Unfortunately I was unable to get AMD drop offs, the Taiwanese ones don't appear to fit great, but won't be seen

The progress, drivers side floor pan in place

Attachment 48245

Attachment 48246

Outer Cowl Panel in place

Attachment 48247

Upper Cowl Panel in place

Attachment 48248

the before

Attachment 48249

The outer cowl panel is not AMD, note how good the fit on passenger side with original outer cowl panel

Attachment 48250

verses how poor the non original outer cowl panel fits to upper cowl

Attachment 48251

The shop is knocking over a few "paying" jobs and hope to get really stuck in to it next week

Rear quarter was trial fitted and appears to fit very well.

Attachment 48252

Now trunk drop offs are here, can do quarters and wheel tubs, also decided to replace trunk floor, rather than repair a few rust holes.

I love the rendering! Its going to look great.

That rendering is definitely sweet. I like that color a lot, good luck with it.