Lateral-g Forums
Page 2 of 6 1 2 34 Last »
Show 40 post(s) from this thread on one page

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)
-   Project Updates (https://www.lateral-g.net/forums/forumdisplay.php?f=16)
-   -   MetalWorks built 1967 Chevelle pro-touring re-vamp (https://www.lateral-g.net/forums/showthread.php?t=50650)

andrewb70 08-13-2015 04:50 AM
Good luck getting the drive line angles right with those BRP mounts.

Andrew

1965_SS 08-14-2015 02:29 PM
Looks like a great project!
You should install a Holley 302-2 oil pan and use lower mounts for the Chevelle. Check out this thread: http://www.chevelles.com/forums/showthread.php?t=717386

MetalWorksClassics 08-26-2015 01:23 PM
Quote:
Originally Posted by andrewb70 (Post 613681)
Good luck getting the drive line angles right with those BRP mounts.

Andrew
These are actually Trans-dapt mounts...but I know what you are saying...they all present issues...with angles.

MetalWorksClassics 08-26-2015 01:32 PM
Budnik wheels
 
3 Attachment(s)
The Chevelle's "Budnik V2" wheels arrived, and they look great.

98ssnova 08-26-2015 05:09 PM
Have you fired up the MSD yet? Curious on how it to setup after the install?

pro66tour 08-26-2015 05:16 PM
Quote:
Originally Posted by Z06Joe (Post 611378)
Love this generation! Gonna keep my eye on this for sure!
MEEE TOOO...:cheers:

MetalWorksClassics 08-27-2015 08:30 AM
MSD fuel injection
 
1 Attachment(s)
Quote:
Originally Posted by 98ssnova (Post 614835)
Have you fired up the MSD yet? Curious on how it to setup after the install?
We have not fired this engine yet, but our shop does a ton of LS conversions, and we LOVE the MSD fuel injection. We also have it on our personal shop car which is a 68 GTO with a pretty radical Wegner Motorsports LS3 in it and it handles that engine great.
The hand held controller steps you through a series of basic questions, then it goes into a self learning mode, and really does an amazing job...we recommend it highly.

andrewb70 08-27-2015 08:28 PM
That engine angle looks extreme. I bet the front operating angle is 10 degrees!!!

Andrew

MetalWorksClassics 09-11-2015 09:54 AM
Tranny tunnel
 
5 Attachment(s)
Here we are opening up the tranny tunnel to allow room for the much larger 4L65E.

MetalWorksClassics 10-01-2015 02:40 PM
Firewall
 
5 Attachment(s)
Here we are filling holes and smoothing off the firewall, then shooting it in semi-gloss black...next is the final install of the LS3.


All times are GMT -7. The time now is 11:09 AM.
Page 2 of 6 1 2 34 Last »
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright Lateral-g.net