Mike for suspension....

Charles for fiberglass....

Next!

Yeah, not real big on communication.....or testing, engineering and apparently metal fab.

Party pooper! Don't you have data to share that shows how unfast you were? :poke:

I shared for a few reasons. The number 2 reason is because, its my opinion, that the new suspension products being put out of this shop dont have anything solid to back them up.....other than they work on the display model in the show room.
:knokwood: :flag2: :thumbsup:

He's blisteringly fast, just put a beer in his hand and ask him. :captain1:

Thanks for the picture Dan. Hopefully this will keep someone from getting hurt. We have been talking about how dangerous they looked from the first time I saw them.

Nothing quite like a heat affected zone in flat sheet metal under ~7500 ft-lbs.

I didn't even know Charles was still putting out suspension parts...

He is, but obviously his quality control leaves a little to be desired...

You've got a lot to learn in the mustang world...🦊