Waiting to hear back from digitails after a call and an email but I may mount them to the lens. Anyone think this would be an issue?

That looks good, almost as if it was designed for that exact placement in the installation. Hopefully the light looks good through the lens when the LED’s are touching it.

Please post the results.

JD

You could put clear silicone on the sides and top and bottom to hold it in on the back side. I'm not talking about a lot, but like a dab in 4 spots.

They sell little 1/4" or a little thinner bumpers for cabinet doors, I think they have them in clear too. Hardware stores or even Walmart had the. you could stick them to the front of the board and place the board in the lens. Maybe a tiny piece of double stick tape or something else to hold the gasket where you need it on the housing.

I think I am gonna go this route. I am hoping some one from Digitails actually returns a call or emai.

Hope all is well with you Wayne!