Al,

Ben busy on other projects at the moment. Funny you ask. I'll be back on it tomorrow. Going to try and finish up the engine bay and front close out panel.

Thanks Mark

It's been a bit. Have a few updates. The air intake set up is done and been slow and steady on the front inner fender wells and close out set-up. Time consuming and a pain in the A!

Mark

Few more of the fenders and panel ideas

Just about have the front section wrapped up

Looks really nice Mark. I like the open engine bay concept that you are showing here. It show off that motor and it will be easy to work on if there is a problem.

https://lateral-g.net/forums/atta...2&d=1351698328

[quote=syborg tt;443919]Looks really nice Mark. I like the open engine bay concept that you are showing here. It show off that motor and it will be easy to work on if there is a problem.

Thanks Marty.
There's still a peace that's going to cover the radiator and front half of the bay. I was going to put a hole for radiator cap axcess,but the customer wants it covered for a cleaner symetrical look. It will be easy to remove for matinace as well. I'm trying to design it so even when that cover is off the bay still looks good and not look like It's missing something

[QUOTE=bentfab;443920]I can't wait to see it when it's done. I am certain it will look nice.

https://lateral-g.net/forums/atta...9&d=1350927221

the above link looks like the panel Foose did on the 69 Camaro's is that the look your customer if wanting ?

Yeah! I just redesigned it so it dosen't go that far into the bay. Now I'm trying to figure the design lay out.

Crappy pick but here's a shot with out the panel

Looks nice - i can't wait to see what you come up with. I remember doing the layout of the inner fenders and core support are on the truck. I must of made 10 different version out of chipboard.

wow beautiful work being done can;'t wait for more updates