No, neither of us are going to SEMA.

You can always call Mike at the shop though.

510-581-7600

I will give you guys a call next week after SEMA. There are a lot of suttle differences.

Are either of you coming down to del mar goodguys.

I dont know if Mike is going to del mar or not, im not. I know he'll be at pleasanton so will i.

I know that if i do get a falcon were going to do a torque arm with a panhard bar in the rear and all of his coil over stuff in the front sitting as low as possible. 17x8 in the front 17x10 in the rear. SBF 331 c.i. and either a top loader or a 5 speed g force...

Sounds like we might have 2 bitchin Falcons around here. :unibrow:

Hey Bryce and other Ford/Falcon guys. Can you tell me whether a Granada Spindle and disc brake set up will just bolt in to the Falcon. Im doing a disc swap on a 64 and would like to use my old Granada/Maverick front brake setup. Will I have to swap out tie rod ends or anything else?

Thanks

I'll have my '63 out in Pleasanton this weekend getting another driving lesson from Mike :willy:

My trans parts shipped last week. I might get to drive the car before 2013

Awesome! how did you do? Any good tips from Maier?

I dont have a granada spindle but it is same ball joints as my 65. The tie rod is different and results in bad bump steer.

I hope so one of us has to have a running car this year:D

:cheers: