Kicker Under Carpet Wiring (( 04-13-23 ))
 

Hi All,

There has not been a lot of progress lately due to lack of time. The charity (www.ridejanieride.org ) that I part of main
event is coming up this weekend and I can't wait. I have been trying to sneak out whenever possible.

It's finally time to tuck the wires under the carpet in the TechFlex undercarpet flat weave.

http://garagescene.net/_data/i/uploa...105014d-me.jpg

http://garagescene.net/_data/i/uploa...3e1690d-me.jpg

http://garagescene.net/_data/i/uploa...83913ec-me.jpg

http://garagescene.net/_data/i/uploa...0aea9ca-me.jpg

I used some Velcro to keep the heat gun trigger on and my bike stand to hold the heat gun.

http://garagescene.net/_data/i/uploa...a692c33-me.jpg

I marked out where the Bitchen center console the Kenny built.

http://garagescene.net/_data/i/uploa...e169a4a-me.jpg

Wire has been neatly routed and protected.

http://garagescene.net/_data/i/uploa...4297b4a-me.jpg

I also received the DEI Under Carpet Lite heat insulation that I will be using in the rear of the car.

http://garagescene.net/_data/i/uploa...0deabc0-me.jpg

I plan to add a little extra in the rear adjacent to the DSE Sub-Frame Connector.

http://garagescene.net/_data/i/uploa...d2a8084-me.jpg

and don't forget to Buckle Up out there.

http://garagescene.net/_data/i/uploa...0501496-me.jpg

I made another To List (( 04-17-23 ))
 

So, I made another to do list and holy crap there is so much more today.

http://garagescene.net/_data/i/uploa...bd380ad-me.jpg

http://garagescene.net/_data/i/uploa...48e6068-me.jpg

http://garagescene.net/_data/i/uploa...5adb5a3-me.jpg

http://garagescene.net/_data/i/uploa...7ff49c7-me.jpg

http://garagescene.net/_data/i/uploa...dc717bc-me.jpg

http://garagescene.net/_data/i/uploa...8396f6f-me.jpg

More Small Projects (( 04-24-23 ))
 

The month of April was very busy for me as every year we do a charity event for local for local family's battling Cancer. The To Do list
that I just posted allowed me to look at everything that I needed to do and it also allowed me to find the small projects that I could do
when I only have a small amount of time.

http://garagescene.net/_data/i/uploa...1eb4cb7-me.jpg

http://garagescene.net/_data/i/uploa...485cd60-me.jpg

http://garagescene.net/_data/i/uploa...aaf5b8f-me.jpg

http://garagescene.net/_data/i/uploa...abe1f4d-me.jpg

http://garagescene.net/_data/i/uploa...884b69a-me.jpg

http://garagescene.net/_data/i/uploa...0bd7fbc-me.jpg

http://garagescene.net/_data/i/uploa...22a03d0-me.jpg

Installing more X Mat (( 05-02-23 ))
 

Another small project.

http://garagescene.net/_data/i/uploa...8de2bf0-me.jpg

http://garagescene.net/_data/i/uploa...9866dc5-me.jpg

http://garagescene.net/_data/i/uploa...937c323-me.jpg

http://garagescene.net/_data/i/uploa...493c5b8-me.jpg

http://garagescene.net/_data/i/uploa...c5aca04-me.jpg

I found rolling the X-Mat to get it inside the door.

http://garagescene.net/_data/i/uploa...c7cd5dc-me.jpg

http://garagescene.net/_data/i/uploa...a930059-me.jpg

I also installed some DEI Under Carpet Lite on the floor.

http://garagescene.net/_data/i/uploa...262f00a-me.jpg

Quick Trip to Home Depot to get a new pair of Snips

http://garagescene.net/_data/i/uploa...f98efa2-me.jpg

http://garagescene.net/_data/i/uploa...11a446c-me.jpg

http://garagescene.net/_data/i/uploa...8a2a71e-me.jpg

http://garagescene.net/_data/i/uploa...ed0b4c0-me.jpg

http://garagescene.net/_data/i/uploa...a462029-me.jpg

http://garagescene.net/_data/i/uploa...2a549cc-me.jpg

Terminator X - Fuel Level Wiring (( 05-06-23 ))
 

I needed connect the fuel level wire to the Holley ECU and of course I forget to run the wire down the passenger
side of the car. I did however run it down the drivers side but Holley wire I needed was on the passenger
side. So, now i have to neatly behind the Vintage Air Unit. Which turned out to be a major pain the backside.

http://garagescene.net/_data/i/uploa...21a8f2b-me.jpg

I of course wrapped the shifter brackets with a towel as they are sharp as can be.

http://garagescene.net/_data/i/uploa...9127416-me.jpg

See those gray wires they are being relocated to the drivers side of the car.

http://garagescene.net/_data/i/uploa...5c6e74c-me.jpg

http://garagescene.net/_data/i/uploa...5b7b56e-me.jpg

http://garagescene.net/_data/i/uploa...d51a04a-me.jpg

http://garagescene.net/_data/i/uploa...fd1d1ae-me.jpg

http://garagescene.net/_data/i/uploa...40499f5-me.jpg

Temporarily connected

http://garagescene.net/_data/i/uploa...9ca868a-me.jpg

Custom Works Front Tow Hook (( 05-08-23 ))
 

I finally pulled the trigger and ordered one of these

http://garagescene.net/_data/i/uploa...67f6532-me.jpg

http://garagescene.net/_data/i/uploa...9dc622c-me.jpg

Another Small Project (( 05-14-23 ))
 

I purchased the Anvil Radiator cover and I needed to add a couple Rivnuts to the outside two holes.

http://garagescene.net/_data/i/uploa...9d76172-me.jpg

http://garagescene.net/_data/i/uploa...3527778-me.jpg

http://garagescene.net/_data/i/uploa...6d8bde3-me.jpg

http://garagescene.net/_data/i/uploa...92000a9-me.jpg

Gates Power Grip Hose Clamps (( 05-14-23 ))
 

I finally installed the Gates PowerGrip hose clamps on the heater hoses.

http://garagescene.net/_data/i/uploa...8f66ac5-me.jpg

http://garagescene.net/_data/i/uploa...7f1757d-me.png

http://garagescene.net/_data/i/uploa...fcf5def-me.jpg

http://garagescene.net/_data/i/uploa...dcd666a-me.jpg

http://garagescene.net/_data/i/uploa...324a78b-me.jpg

http://garagescene.net/_data/i/uploa...4ae502a-me.jpg

http://garagescene.net/_data/i/uploa...2cb08ed-me.jpg

http://garagescene.net/_data/i/uploa...0469a71-me.jpg

http://garagescene.net/_data/i/uploa...919ad15-me.jpg

Eventually, I will install the Gates clamps on the Water Pump

http://garagescene.net/_data/i/uploa...83e17f6-me.jpg

Coming along nicely, Marty!

Great updates Marty, as usual.