Thanks!

Thanks Gus!

Pic of the radiator hoses

http://i1017.photobucket.com/albums/...8/c95b1910.jpg

3.5"-3.5" 90 degree rubber intake tube came yesterday and it fits great!

http://i1017.photobucket.com/albums/...8/46ff8138.jpg

http://i1017.photobucket.com/albums/...8/a87c0a00.jpg

http://i1017.photobucket.com/albums/...8/d46b900c.jpg

We moved the seats in about an 1" each side

http://i1017.photobucket.com/albums/...8/bab9377a.jpg

Looking good Tyler.

Modified the harness so we can tuck the wires away on the back side of the motor

http://i1017.photobucket.com/albums/...wmo8/078-2.jpg

http://i1017.photobucket.com/albums/...wmo8/079-1.jpg

The computer will be tucked away in the passenger fender and will never be seen when we make new inner fender panels

http://i1017.photobucket.com/albums/...wmo8/087-1.jpg

Pretty slick. :thumbsup: Are you going to have an access panel for the diagnostic port on the PCM?

We sure are! We were thinking of putting the pcm under the dash but i think this will work out better.

Nice to see some progress. That looks like a nice place for the ECU.

Thanks Wayne! Progress has been slower but we have been picking up parts in the meantime. Picked up a red top optima, some magnaflow mufflers, and some 2.5" stainless exhaust tubing. Also have been playing with different intake setups and we are going to start machining a mass airflow sensor housing.

Took it off of the rack again

http://i1017.photobucket.com/albums/...mo8/009-16.jpg

http://i1017.photobucket.com/albums/...mo8/007-15.jpg

:thumbsup:

Looks awesome. Is there much more to go?