Thank you. That one really stretched me. There is still some welding that needs to be done, but it is minor.

Bill

Very nice work on the trans tunnel Bill.

Thanks. Everyone here is alsways ready to support. It drives me to continue and try new things.

Bill

Latest update. Got the engine harness routed so I could move toward the two bulkhead connectors for the pass through on the firewall. I made a pin-out list so that I could keep up with what goes where.

Started plugging in each wire.

Once I knew where each wire was going in the connector and crimping on the terminals.

After a long Saturday, every wire was terminated and in the connector.
Next step is to get the covering on the wires for all of the harness.

I think I will start on the rear bumper next. Man these things look horrible for the fit.

Thanks Bill. I have the same wiring bulkhead to look forward to. :lol:

Well, it seems I haven't been keeping up with this thread like I should. However, with some life issues like the passing of my father-in-law and the birth of a grandson, some things take precedent.

So I left off with the rear bumper. I started working to try to make it fit better, not necessarily to custom flush and mold the bumper to the body, but to just bring them in t the end, and make them line up with the body a little better.